H
EDGE
C
LIPPER
O
PERATOR
'
S
M
ANUAL
27
SHC-1700, 2100, 2400, HCA-2400
Tools required: Grease Gun with Lithium Grease, Rag.
Parts required: Lithium Based Grease.
1.
Clean dirt from grease fittings.
2.
Carefully pump grease in each fitting. DO NOT force grease.
Too much pressure will force grease past seals and cause damage.
Apply 1-2 pumps of grease every 15-20 hours of operation.
Drive Shaft Assembly
NOTE
Hedge Clipper drive shaft should be greased every 25-50 hours of
operation.
Tools required: 8 mm Open End Wrench, Screwdriver, Clean Rag,
Small Brush.
Parts required: Lithium Based Grease.
WARNING DANGER
Shaft Hedge Clipper blades are very sharp. Wear gloves to protect
hands, otherwise serious personal injury may result.
1.
Loosen gear housing assembly locating screw (A) and mounting
screws (C). Remove the gear box from the drive shaft housing.
2.
Pull the drive shaft (B) from the housing, wipe clean and re-coat
with a thin coating [1/2 oz. (15 ml)] of lithium based grease.
3.
Slide the drive shaft back in the drive housing being careful not to
get dirt on the flex shaft.
4.
Install the gear housing assembly.
B
A
C
HCA-2400
SHC-1700,
2100, 2400
HCA-2400
SHC-1700,
2100, 2400
