15
6 INCH CHIPPER
ENGLISH
OPERATION
The Main Menu is at the center of the screen. The menu
is navigated by using the up and down keys on the
Navigation Button, located directly below the menu.
After selecting the menu option of your choice, use the
Enter key on the far right to move to the selected screen.
The Main Menu has six selections:
●
Chipping Screen –
The chippers’ feed roller system
is controlled from this screen. The Chipping Screen
can also be selected by the button to the right of the
Navigation Button.
●
Hours/Service Reminders –
Shows the total hours
on the chipper as well as hours remaining until the
next service on the blades/anvil, belts, bearing
lubrication, engine or hydraulic system is required.
If the chipper needs service, a service reminder
will flash just above the Enter key. The user should
navigate to the Hours/Service Reminders screen for
more information on the service required. The Hours/
Service Reminders are described in Section 4.7.3.
●
Diagnostics –
Faults in the chipper control system,
which can be detected by the controller, are shown
here.
●
Operation –
Contains basic information on the
operation of the chipper. Navigate the three screens
of this section with the Navigation Button.
●
Troubleshooting –
Basic troubleshooting information
to help diagnose problems with the engine, belt drive
or other problems that may occur during chipping.
Navigate the screens of this section with the
Navigation Button.
●
Language –
Allows the selection of the language
displayed on the controller. Choices are English,
French, Spanish and Portuguese.
4.7.2 CHIPPING SCREEN
To begin chipping, the user needs to enter the Chipping
Screen (see Figure 4.2). This can be done in one of two
ways:
1. Selecting Chipping Screen from the Main Menu and
pressing Enter, or
2. Pressing the Chipping Screen button to the right of
the Navigation Button.
In the upper left hand corner of the screen is a reminder
that the feed roller speed can be adjusted. The adjustment
occurs at the control valve, the location of which varies by
model. In general, the speed of the feed roller should be
slower for large diameter material and faster for smaller
diameter material. See chipper owner's manual for
detailed instructions.
Below the Feed Roller Speed image is an empty area of
the screen that will flash Check blades/anvil when the
chipper blades or anvil require service.
After servicing the blades and anvil, the service indicator
will need to be reset. See Section 4.7.3 for information on
resetting the service indicators.
The large indicator in the upper right hand corner and the
text box below it will give one of four indications:
●
Flashing Green –
The chipping rotor has not achieved
enough RPM to begin chipping. It is not possible to
engage the feed roller in the forward direction when
the indicator is flashing green. The text box below the
indicator will display "RPM Not Met."
Figure 4.1, DDC Main Menu
The Chipping Screen is accessible from any screen by
pressing the Chipping Screen button.
NOTE
Figure 4.2, Chipping Screen
Consult the Controller Manual (P/N 71983-00) for
more information on using the Diagnostics screen to
help troubleshoot the chipper control system.
NOTE