7
6 INCH CHIPPER
ENGLISH
ASSEMBLY
1.
Attach the feed chute (1) to the chipper body using six
3/8 x 1-1/4" carriage bolts (2), four 3/8 x 1" carriage
bolts (7) and nylock flange nuts (hardware already
installed on chipper, reuse to attach feed chute).
The upper bolts are inserted from inside feed roller
housing. The lower bolts are inserted from inside the
To install the rear stabilizer, slide the stabilizer into the
corresponding bracket beneath the rear of the chipper
frame. Adjust the stabilizer and secure with the provided
snap pin.
Figure 2.2, Rear Stabilizer
Do not operate this unit without the chipper chute
correctly installed. Rotating cutting blades can cause
serious personal injury.
WARNING
Figure 2.4, Chipper Chute Assembly
1
2
3
4
5
6
7
7
In tropical regions, areas of high humidity or rainfall
amounts, dielectric grease may be added to wire
harness connectors to provide corrosion resistance.
NOTE
2.3 INSTALL REAR STABILIZER
2.4 ATTACH LICENSE PLATE LIGHT
2.5 ATTACH CHIPPER CHUTE
1. Attach the license plate light to the chute support,
which is located under the feed chute, with two #10-
24 nuts and two #10-24 x 1/2" screws.
2. Plug the wire harness into the license plate light.
Figure 2.3, License Plate Light
feed chute. The other six bolts mount on the outer
flanges of the right and left chute supports through the
feed roller housing. Install a coated clamp (3) in the
lower left mounting hole. Do not tighten completely at
this time. Route wire harness through clamp.
2.
Bolt the chute support (5) to the chipper frame with
two 3/8 X 1" bolts (4), washers and nylock nuts.
3.
Bolt the chute support (5) to the feed chute hinge by
removing the existing 3/8 X 1-1/4" hex bolt (6) and
nylock nut and replace in the same location securing
the chute support.
4. Now go back and tighten the bolts and nuts
attaching the feed chute to the housing.
5. Connect the wire coming from the feed chute to the
connector that is located underneath the chipper feed
roller.
CH6627H MODEL
CH6627HXE MODEL
