20
EN
INSTALLATION
Part 1A – Installing the Wall Plate (Drywall)
IMPORTANT!
For safety reasons, this mount must be secured to a wood stud. The stud must be capable
of supporting the combined weight of the mount and the display.
1. Use a high quality stud fi nder to locate a single stud where you want to install your mount.
2. Mark both edges of the stud to help identify the exact center (see illustration).
Left edge of stud
Right edge of stud
Center of stud
3. Place the wall plate over the center of the marked stud and level it using the integrated bubble level.
4. Mark the two holes for securing the mount and set the wall plate aside.
5. Drill a pilot hole at each marked location using an electric or portable drill and 1/8” (3 mm) bit.
6. Move the wall plate back into position and secure it using the Drywall Screws (A) from the hardware
kit.
Do not over-tighten these screws.
Part 1B – Installing the Wall Plate (Concrete)
IMPORTANT!
For safety reasons, the concrete wall must be capable of supporting the combined weight
of the mount and the display.
1. Place the wall plate against the wall in the desired location and level it using the integrated bubble level.
2. Mark the two holes for securing the mount and set the wall plate aside.
3. Drill a 5/16” (8 mm) hole at both marked location. Remove any excess dust from the holes.
4. Insert a Concrete Anchor (P) into each hole so that it is fl ush with the concrete surface. A hammer
can be used to lightly tap the anchors into place if necessary.
NOTE:
If the concrete wall is covered by a layer of plaster or drywall, the concrete anchor must pass
completely through the layer to rest fl ush with the concrete surface.
5. Move the wall plate back into position and secure it using the Drywall Screws (A) from the hardware
kit. Do not over-tighten these bolts.
