GB
HOT AIR STYLER
26
26
SAFETY INSTRUCTIONS
Read carefully and save for future use!
Warning:
The safety measures and instructions, contained in this
manual, do not include all conditions and situations possible. The user
must understand that common sense, caution and care are factors that
cannot be integrated into any product. Therefore, these factors shall be
ensured by the user/s using and operating this appliance. We are not
liable for damage caused during transportation, improper use, voltage
fluctuation or any change or modification of any part of the appliance.
To protect against a risk of fire or electric shock, basic precautions shall
be taken while using electrical appliances, including the following:
1. Make sure the voltage in your outlet corresponds to the voltage
provided on the appliance label and that the socket is properly
grounded. The outlet must be installed in accordance with
applicable electrical codes according to EN.
2. It is recommended that to install residual current protection (RCD)
for better protection with nominal tripping current not exceeding
30 mA in the bathroom electrical circuit. Ask your electrician for
advice.
3. Do not operate straightener with a damaged cord.
All repairs
including cord replacements shall be performed by
a professional service centre! Do not remove protective covers
of the appliance, risk of electric shock!
4. Protect the appliance against direct contact with water and other
liquids, to prevent potential electric shock. If the hot air straightener
falls into water, unplug the cord from the outlet immediately.
5. When using the appliance in the bathroom disconnect it after use
by pulling the plug from the power supply, because the proximity
of water presents danger even when the appliance is switched off.
Do not leave the hot air straightener running unattended. For safety
reasons switch off the curling iron whenever you set it aside.
6. Leaving the hot air straightener cord connected to outlet
unattended is not recommended. Disconnect the cord from the
electrical outlet prior to performing maintenance. Do not pull the
cord from the outlet by yanking the cord. Unplug the cord from the
outlet by grasping the plug.
