ECG HH 2010, Instruction Manual

Page: 8 / 68

English English
8
Protection against overheating
The internal thermal fuse protects the heater from overheating and automatically shuts it off. In this case, the
operating indicator turns off.
If the device shuts itself off, disconnect it from the electrical outlet. The device is ready to use again after it cools
(in about 15 minutes}. Plug the power cable back into the socket.
If the situation repeats, first check that the thermostat controller is set correctly and that the ventilation holes
are not covered.
CLEANING AND MAINTENANCE
Always pull the power cord out of the outlet before cleaning and wait for it to cool down completely. Clean
the outer surface of the device with a damp cloth. Do not use sharp or abrasive agents to clean the device,
otherwise the surface can become damaged.
You can put the device in storage only after proper switching off the main switch, disconnection from the
outlet and after complete cooling.
STORAGE OF THE DEVICE
If you do not plan to use the device for a longer period of time, you should store it in a clean and dry place
protected from dust.
TECHNICAL DATA
HH 2010
Max. input power: 2000 W
2 power levels: 1000 W and 2000 W
Built-in fan
Continuous thermostat regulation
Safety cut out switch
Free-standing
Nominal voltage: 220–240 V~ 50 Hz
Nominal input power: 2000 W
HH 3010
Max. input power: 3000 W
2 power levels: 1500 W and 3000 W
Built-in fan
Continuous thermostat regulation
Safety cut out switch
Free-standing
Nominal voltage: 220–240 V~ 50 Hz
Nominal input power: 3000 W