English
English
20
The intended
water temperature
was not reached,
defective heating
element and
sensor.
•
Contact service
Active alarm –
water overflowing
•
Turn off the appliance and close
the taps.
•
Contact service
Defective
electronic card
•
Contact service
Installation and repairs must always be performed by an authorized service representative to avoid possible
risks. The manufacturer is not liable for damage that may occur during procedures performed by unauthorized
persons. Only a technician may perform repairs. If you need to replace a part, be sure to use only genuine spare
parts.
Improper repairs or the use of non ‑original spare parts can cause considerable damage and expose the user
to considerable risk.
Contact information for customer service can be found in the enclosed warranty.
One of the program lights is on and the Start / Pause light turns off and on
The appliance door is open, close it.
The program does not start
•
Make sure the plug is plugged in.
•
Check the fuses.
•
Check that the tap on the water supply is open.
•
Make sure you close the appliance’s door.
•
Check is you have switched off the appliance by pressing the On/ Off button.
•
Check that the filter on the water supply and the filters in the appliance are not clogged.
The "Wash" and "End" lights are flashing
•
Active alarm – water overflowing
•
Switch off the water supply and contact an authorized service center.
The lights do not go out after the program is completed
The On/Off button is still on.
Detergent residues remain in the detergent dispenser
The detergent was added to wet detergent dispenser.
Water remains in the appliance at the end of the program
•
The drain hose is clogged.
•
Filters are clogged.
•
The program is not yet completed.
The appliance stops during washing
•
Power failure.
•
Water supply failure.
•
The program could be in a standby mode.
There is noise during washing and the appliance shakes
