English
English
9
Note: Remove shipping screws before first use of the washing machine. Malfunctions caused by
operating the washing machine with the installed shipping screws are not covered by the
warranty.
Adjusting the leveling feet / adjusting the adjustable stops
1. Do not install the washing machine on a surface
(e.g. carpet) that would prevent ventilation from
below.
•
To ensure quiet, vibration-free operation, install it
on a solid surface.
•
You can level the washing machine with the
adjustable feet.
•
Loosen the plastic lock nut.
2. If you want to increase the height of the washing
machine, turn the feet clockwise. If you want to
lower the height of the washing machine, turn the feet counterclockwise.
•
Once the washing machine is levelled off, tighten the lock nuts by turning them clockwise.
3. Never put underneath the washing machine cardboard, wood or any other similar materials.
•
When sweeping and washing the floor on which the washing machine is placed, take care not to disturb
the horizontal position of the washing machine.
Electrical wiring
•
The washing machine requires power supply of 220-240 V, 50 Hz.
•
The power cable of your washing machine is equipped with a grounded plug. This plug should always be
inserted into a 10 A grounded outlet.
•
If you do not have a suitable outlet and a grounded fuse, consult a qualified electrician.
•
We are not liable for damages resulting from connecting the appliance to an ungrounded outlet.
Note:
Operating the washing machine at low voltage shortens the service life and reduces its efficiency.
Water supply hose
1. Depending on the specifications of the washing machine, your washing machine may be connected to a
cold water supply or to a cold and hot water supply. A hose with a white cap should be connected to the
cold water supply and a hose with a red cap to the hot water supply (if available).
•
To prevent water leakage into the joints, 1 or 2 nuts are supplied in the hose package (depending on the
model of your washing machine). Attach these nuts to the end of the supply hose that connects to the
water supply.
2. Connect the new supply hoses to the ¾ ˝ threaded water tap.
•
Connect the white end of the supply hose to the white supply valve on the back of the washing machine
and the red end of the hose to the red supply valve (if used).
•
Tighten the joints manually. If in doubt, contact a qualified plumber.
•
Water flow with a pressure of 0.1 - 1 MPa will allow your washing machine to work with optimal efficiency
(pressure 0.1 MPa means that more than 8 liters of water per minute flow through a fully open tap).
3. Once all connections have been made, turn on the water supply and check for leaks carefully.
4. Make sure that new water supply hoses are not pinched, kinked, twisted, bent or crushed.
•
If your washing machine is connected to a hot water supply, the hot water supply temperature should not
be higher than 70 ° C.
1
