TDS-100M Manual
9
28
When signal set turning poor,keep last datas,choosing”yes”means when the signal
turning poor,the flow meter display last correct measured datas.
29
。
Input signal strength when the pipe flow is set to be empty.for example:inputing 65
means when the signal strength is lower than 65,the flow meter will think that there is no
liquid in the pipe and display the flow value as zero.
30
choose metric or imperial unit
31
choose instant flow rate unit
32
choose totalizer unit
33
choosing the totaliser multiplying factor which function is to multiply totaliser data
rang,normaly set it as x1
34 net
totaliser
switch
35
positive totaliser switch
36
negative totaliser switch
37
restore parameters setup before leaving factory and reset totaliser
38
manual totaliser(the key to control on/off)
39
choose operating language,including 8 kinds of different languages for international
users to use
flow
unit
setup
3•
setup the LCD display method,inputing 0 or 1 means regular displaying content.inputing
2-39 means automatically cycle displaying method,displaying the previous menu of
2-39,time interval is 8 seconds.when inputing accures ,displaying according to the
inputing operation.when there is no inputing operation,it will automatically enter cycle
displaying status.(detailed information in §3.1)
*
40
damper coefficient
*
41
Input low flow velocity cutoff value
42
Setup static zero point
43
clear zero point setup and manually setup zero point,restore default before leaving
factory.
44
Set up zero point deviant by hand
45
meter coefficient,rectification coefficient
46
input Network address identification number (IDN)
47
password protecting operation,after the meter was setup with password,only browse
menus without any modification.
48
Input degree of linearity broken line rectification data.at most there is 12 segments
broken line,used for users to rectify meter nolinear.
Choo
sing
setup
49
Network communication tester,on this window to visit the datas transfered from upper
computer to judge the problems arised during communication.
50
Optional setup of datas output at scheduled time,choose output content at scheduled
time to print,more than 20 to selet
51
Setup output time at scheduled time
sched
uled
time
output 52
Printing data flow direction control.by default printing data will flow directly to the
thermal printer hanged inside bus.setup printing data output to outside serial
port(RS485 port)
