Page 3 of 7
TOP VIEW
Figure 4
SIDE VIEW
Figure 5
Standard Mounting without Shroud:
Figure 6
Figure 7
Mounting with VHB Tape:
1. Carefully remove the light head from the shroud.
CAUTION: gently release the locking tabs to avoid breaking the tabs
shown in Figure A .
2. Clean the light head brackets with supplied alcohol wipe. * for extra
adhesion, see notes below.
3. Remove one side of the adhesive liner & apply to both brackets. Apply
light pressure for 20 seconds.
4. Insert bracket as shown on Figure B.
5. WITHOUT removing the second adhesive liner, hold the product to
desired location. Adjust the light head to its desired angle by adjusting the
bracket.
6. Clean mounting surface with supplied alcohol wipe. *for extra adhesion,
see notes below.
7. Remove the second adhesive liner.
8. Apply product on to the treated surface. Apply light pressure for 20
seconds.
9. Insert the provided screws in the light head locking mechanism as shown
in Figure C. This will hold the brackets in position & the light head in the
desired angle.
** MOUNTING HARDWARE NOT PROVIDED
Figure 8
Mounting with Suction Cup:
1. Carefully remove the light head from the shroud.
CAUTION: gently release the locking tabs to avoid breaking the tabs
shown on Figure A.
2. Remove the suction cups from the shroud mounting brackets.
3. Install each suction cup to each bracket using the existing screws as
shown on Figure D.
4. Insert bracket as shown on Figure B.
5. Clean mounting surface with supplied alcohol wipe.
6. Apply the product on to the treated surface gently pressing the suction
cups on to the glass. Apply light pressure for 20 seconds. Gently adjust
the light head to its desired angle if needed.
7. Insert the provided screws in the light head locking mechanism as shown
in Figure C. This will hold the brackets in position & the light head in the
desired angle.
Mounting with Hardware (NOT PROVIDED):
1. Carefully remove the light head from the shroud.
CAUTION: gently release the locking tabs to avoid breaking the tabs
shown on Figure A.
2. Insert the light head bracket as shown on Figure B.
3. Hold the product to desired location. Adjust the light head to its desired
angle by adjusting the bracket.
4. Clean mounting surface with supplied alcohol wipe.
5. Install product on to the treated surface by using #8 hardware screw (not
included) as shown on Figure E. Torque screws to 8 ± 2 in-lbs.
6. Insert the provided screws in the light head locking mechanism as shown
in Figure C. This will hold the brackets in position & the light head in the
desired angle.
*For extra adhesion, use 3M Tape Primer. For product & application information, go to:
https://multimedia.3m.com/mws/media/65952O/3mtm-tape-primer-94.pdf
