920-0014-00 Rev. C
Page 1 of 5
IMPORTANT!
Read all instructions before installing and using. Installer: This manual must be
delivered to the end user.
Installation and Operation Instructions
LightBar
Do not install and/or operate this safety product unless you have read and understand the safety
information contained in this manual.
1. Proper installation combined with operator training in the use, care, and maintenance of emergency warning devices are
essential to ensure the safety of you and those you are trying to protect.
2. Exercise caution when working with live electrical connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high
current arcing, which can cause personal injury and/or severe vehicle damage, including fire.
4. Proper placement and installation are vital to the performance of this warning device. Install this product so that output
performance of the system is maximized and the controls are placed within convenient reach of the operator so that s/he can
operate the system without losing eye contact with the roadway.
5. It is the responsibility of the vehicle operator to ensure during use that all features of this product work correctly. In use, the
vehicle operator should ensure the projection of the warning signal is not blocked by vehicle components (i.e., open trunks
or compartment doors), people, vehicles, or other obstructions.
6. The use of this or any other warning device does not ensure all drivers can or will observe or react to a warning signal.
Never take the right-of-way for granted. It is your responsibility to be sure you can proceed safely before entering an
intersection, driving against traffic, responding at a high rate of speed, walking on or around traffic lanes.
7. This equipment is intended for use by authorized personnel only. The user is responsible for understanding and obeying
all laws regarding warning signal devices. Therefore, the user should check all applicable city, state, and federal laws and
regulations. The manufacturer assumes no liability for any loss resulting from the use of this warning device.
8. This product contains high intensity LEDs, staring directly into these lights could result in temporary and/or permanent vision
impairment.
WARNING!
Failure to install or use this product according to manufacturer’s recommendations may result in property
damage, serious bodily/personal injury, and/or death to you and those you are seeking to protect!
6221000 SERIES
Permanent Mount
Strobe Bar
Specifications:
Size:
22.4” x 8.4” x 5.8”
Weight:
7 lbs.
Voltage:
12 to 24 VDC
Current Draw: 3.8 Amps. Max.
Unpacking:
Carefully remove the strobe bar and place it on a flat
surface. Examine the unit for transit damage. If damage is
found, contact the transit company or ECCO. Do Not use
damaged or broken parts
ECCO Customer Service Team 1-800-635-5900
Introduction:
The ECCO 6221000 series combines 2 synchronized strobe heads into a 22” bar, and is field selectable for double or quad
flash mode. The flash rate is 70 double flashes per minute in double flash mode or 65 quad flashes per minute in quad
flash mode (each strobe head).
