Page 6 of 14
NOTE: GREEN AND YELLOW
WIRE FUNCTIONS ARE
SWAPPED IN LIGHTBARS WITH
PASSENGER SIDE CABLE EXIT.
USE THE RED WIRE IN 3-WIRE
SYSTEMS ONLY.
IGNITION
SWITCH
12+ Pro Vantage
™ Lightbar
STTs OPTIONAL
Optional Stop/Tail/Turn
(STT) Cable
BROWN (TAIL)
YELLOW (LEFT TURN)
GREEN (RIGHT TURN)
RED (STOP)
WHITE (STT GROUND)
BLACK
RED
Gray - Worklights
ORG/BLK - Takedown Lights
Pink - Arrowstik Left
Orange - Arrowstick Right
YLW/BLK - Arrowstik Flash
GRN/BLK - Level 1
Yellow - Left Alley
Purple - Right Alley
BLU/BLK - Rear Cut
PUR/BLK - Front Cut
Brown - Left Cut
Green - Cruise
WHT/BLK - Level 2
RED/BLK - Level 3
1-2 A
1 A
Blue - Dim
BLU/WHT - Program Patterns
White - Arrowstik Pattern
GRAY/BLK - Ignition Wire
Power/Ground Cable
See Fuse
Recommendations
on Page 1
4-Pin Connector
NOTE: Not all SIB input wires
are used.
SIB
SERIAL INTERFACE BOX (EZMATSIB)
Occasional cleaning of the lenses will ensure optimum light output. Take care when cleaning
lenses – although tough, polycarbonate scratches easily. Clean the lens and base with soap
and water or a lens polish using a soft cloth. Do not use solvents as they may damage the
polycarbonate. Do not subject the lightbar to high-pressure washers or automatic car washers.
Lens Removal and Installation
1. Remove the screws from the lenses. Starting at one edge, pull the lens off.
2. Carefully lift the lens off the seal – choose a suitable location to temporarily store the lens so
as to not scratch the surface.
3. When reinstalling, gently apply pressure around the lens taking care not to damage the
seal. Replace the screws.
Warning LED Modules (EZ1203X, EZ1206XX)
The LED lightheads have been designed to ensure long service life using high performance
LEDs. The modules are low profile units that have a high intensity output with low current draw.
The LED lightheads can be mounted in the front, rear and corners of the lightbar.
Maintenance
12+ Pro Vantage™ Lightbar
STTs OPTIONAL
Optional Stop/Tail/Turn
(STT) Cable
BROWN (TAIL)
YELLOW (LEFT TURN)
GREEN (RIGHT TURN)
RED (STOP)
WHITE (STT GROUND)
NOTE: GREEN AND YELLOW
WIRE FUNCTIONS ARE
SWAPPED IN LIGHTBARS WITH
PASSENGER SIDE CABLE EXIT.
USE THE RED WIRE IN 3-WIRE
SYSTEMS ONLY
Power/Ground Cable
BLACK
RED
See Fuse
Recommendations on
Page 1.
IGNITION
SWITCH
4-Pin Cable
NOTE: Not all SIB input wires
are used.
GRAY/BLACK - Ignition Wire
BLACK
RED
BLUE
YELLOW
YELLOW - Left Alley
PURPLE - Right Alley
GRAY - Worklights
ORANGE/BLACK - Takedown Lights
PINK - Arrowstik Left
ORANGE - Arrowstik Right
YELLOW/BLACK - Arrowstik Flash
GREEN/BLACK - Level 1
WHITE/BLACK - Level 2
RED/BLACK - Level 3
BLUE/BLACK - Rear Cut
PURPLE/BLACK - Front Cut
BROWN - Left Cut
GREEN - Cruise
BLUE - Dim
BLUE/WHITE - Program Patterns
WHITE - Arrowstik Pattern
