2
Programming Manual
1.
Programming the system
The system can be programmed in two ways;
1.
Throw the unit’s front keypad – to be used by the installer.
2.
Or by calling the system with the MASTER phone number and do the programming
wirelessly via the phone. The master number must be programmed into the system first, via
the keypad.
Entering Program Mode (PM)
Use the keypad to enter
PM
as follows:
-
Press and hold the # button for three seconds till your hear long beep (one second Beep).
-
Enter installers pin code number.
The factory default installer’s pin code is 9 9 9 9.
-
Then you will hear: “
You entered program mode
”
-
Or you will hear: “
Wrong command”
, in case of a false attempt. You would need to
repeat
the steps for entering program mode once again from start.
In Program Mode you can program the following:
(A) Program the phone numbers into the system.
1.
Program the Master Phone Number:
Press:
0 0 0 * enter master phone number #
Then you will hear the announcement:
“The number is ….”
Note !
The system will always answer the call made by the MASTER phone number and then enter Program Mode
automatically, to allow the “master” to do all the programming wirelessly using his phone’s keypad.
2. Programming the users’ phone numbers:
The following letters and configuration, represent the programming sequence for users’ phone numbers:
o
The first three digest (
U U U
) represent the house number. From 001 to 333.
o
The 4
th
digit (
N
) represents the 1
st
or the 2
nd
or the 3
rd
phone number for the house.
o
( *
P P P …. P P P
* ) the letters P represent the phone number entered.
o
( R )
represent the number of
R
ings (from 1 to 9 rings) that the unit would wait for an
answer, before it would hang up and dial the next phone number in the memory.
Recommended number of rings is: 5 rings (about 15 seconds).
o
(
#
)
to enter the information into the system. The system will announce the phone number as
a confirmation: “
The number is …”
U
N
U
U
P
P
P
P
P
P
R
.
.
.
