Chengdu Ebyte Electronic Technology Co.,Ltd.
User Manual
Copyright ©2012–2020
，
Chengdu Ebyte Electronic Technology Co.,Ltd.
45
Figure 4-25 D1258C00000294 Receiver configuration writing steps
D. The second communication parameter is configured in pairs: check the communication mode of the product model →
check the writing procedure of the second communication configuration according to the communication mode → refer
to the chapter "parameter reading, description and writing of the second communication mode".
Example: The second communication method is: LoRa wireless spread spectrum. In the second communication
configuration writing step, it is necessary to configure the LoRa channel, LoRa address, and LoRa airspeed of the sender
and the receiver to be the same. For details, see the "Second Communication Method: LoRa" chapter.
2. D1258C00000294 configuration steps (as shown in Figure 4-26 below): (configuration method: the same as the
sender)
A. Configuration and write parameter content: pairing mode "channel self-organization", channel self-organization
information, parameter configuration of the second communication method.
B. Open the "Interconnection Network IO Setting Tool" → select the correct COM port number and the correct (default)
parameters → click "Open Serial Port" (if the parameters have been changed and forgotten, you can restore the factory
settings, follow method 1) → "Search /Read Device" → "4. Mode Configuration" → select the pairing method as
"channel self-organization" → the channel correspondence is shown in Figure 4-23 above; the target S/N unique
identification code and channel configuration are written as shown in Figure 4- 26 → Click "Write" in "4. Mode
Configuration" → observe the log column, prompting success → Click "Save" → Click "Restart" → Finish.
C. Next, check → Repeat the chapter "Mode Configuration Parameter Read" to confirm whether the configuration is
successful.
