Chengdu Ebyte Electronic Technology Co.,Ltd.
User Manual
Copyright ©2012–2020
,
Chengdu Ebyte Electronic Technology Co.,Ltd.
35
(2) Steps (see Figure 4-13 below): Select the correct COM port number and correct (default) parameters → click "Open
Serial Port" (if you have changed the parameters and forget them, you can restore the factory settings) → "Search/Read
Device" → "4. Mode configuration" → Click "Read" in the mode configuration → you can view the above parameters:
(Note: The reading method of the sender and the receiver is the same.)
Figure 4-13 Mode configuration Parameter read
4.4.2 Mode configuration and parameter description
(1) Pairing method: For the networking method of paired transmission (remote transmission) products, see the following
table 4-3
Table 4-3 Pairing method description
Pairing method
Description
Other
One-to-one (default)
1 sender corresponds to 1 receiver. Data is
transmitted between devices.
Factory default
One-to-many (with
reply)
1. One sender corresponds to multiple receivers.
Data is transmitted between devices, and the
values of each channel on the receiver are the
same.
2. After receiving the data, all receivers will
reply to the sender.
Compared to one-to-many (no reply):
1. Advantages: The sending end and the
receiving end are connected to the NET
indicator light, which will give an indication,
which is convenient for network connection
judgment.
2. Disadvantages: There are too many
receivers, and each receiver sends
information to the sender, which is prone to
data conflict at the sender, resulting in
abnormal output from the receiver.
One-to-many (no
reply)
1. One sender corresponds to multiple receivers.
Data is transmitted between devices, and the
values of each channel on the receiver are the
same.
2. After receiving the data, all receivers will not
reply to the sender.
Compared to one-to-many (with reply):
1. Advantages: There are too many receivers,
each receiver will not send information to the
sender, so it will not cause data conflict on the
sender, and the output of the receiver is not
prone to abnormality.
2. Disadvantage: The NET indicator light on
the sending end will not give an indication,
and you can only check the status of the NET