LX20B – Manual
Page 40 / 67
In this column you define signals that may be reported at monitoring station with
SMS messages – when there is no connection with server over GPRS. There is
possibility to send information on alarms (input state change from rest to action
status) and on returns of input state from action to rest (normalization).
To transmit any signal you should only click it (proper square on your right).
Click on [Clear] button to remove all marked signals.
Click on [Invert] button to change markings to contrary.
7.4.3.
Skip initial state
This option allow for locking of sending of information on status of active inputs at
power connection. Information on inputs will be sent to server after the first change
from inactive to active status.
For the events “Power” and “Battery” no selection “Skip initial state” will cause
sending information about the power supply / battery on boot device regardless of
the power supply / battery state.
7.4.4.
Power loss
One of device additional options is monitoring of power supply voltage. As short
voltage drop may follows at some facilities, it is possible to avoid reporting by
entering time after which information will be sent.
Value of this parameter means that voltage drop shall follow within this determined
time so that device recognizes it as real voltage drop and that information might be
sent.
7.4.5.
Event: CLIP
Icoming call from the number defined in option: Inputs/Outputs –>Output 1 (OUT1)
/ Output 2 (OUT2). The phone number is entered at option: “When icoming call
detected from number” (see item 7.3.3.2.).
7.5.
RESTRICTIONS
In this section you can define the limits for the numbers of which SMS are sent to
the transmitter with commands and CSD connections are established. You can also
specify the period of validity of the sent SMS and SMS limits.
7.5.1.
SMS Authorized phones
User may restrict remote access to the device (via SMS) for determined phone
numbers. A list of numbers (up to 5 numbers) determines which numbers are
allowed to connect with transmitter.
Available options:
Deny all: means no available telephone communication.
Allow all: means that telephone communication is possible from any phone.
Allow chosen: means that telephone communication is possible only from these
numbers that are on the list. It is possible to list up to 5 phone numbers.
Summary of Contents for LX20B
Page 57: ...LX20B Manual Page 57 67...
