CPX200NW ALARM CONTROL UNIT – USER MANUAL
11 / 28
EN
5.
ARMING THE SYSTEM
5.1.
ARMING THE SYSTEM
5.1.1.
ARMING FROM KEYBOARD
1.
Enter your code and press
. 3 beeps will confirm the code.
Note: If incorrect code is entered the keypad will emit long
constant sound. Repeat the arming process by entering the
correct code.
2.
Leave the facility before the time for leaving expires. That state is indicated
by intermittent sound and quick flashing the ARMED LED on the keypad until
the system gets fully armed. If the chirps are activated the arming will be
confirmed by one chirp of siren.
Note: If the partition is not plugged to any zones, the
partition is not armed.
5.1.2.
ARMING FROM REMOTE CONTROL
Press the remote control buton indicated by the closed padlock symbol
,
assigned to the arming function. Keyboard confirms arming by lighting ARMED
LED. If the chirps are activated the arming will be confirmed by one chirp of
siren.
Note! The control panel allows you to assign remote control buttons to various
functions. It is possibile to configure different arming button.
5.2.
ARMING THE SYSTEM WITH FAULT
If during the arming any faults are present in the system, the keypad will indicate it
with flashing ARMED and SYSTEM LEDs and long constant audio signal. LEDs 1 to 8
will indicate which system errors are present. That state will maintain for 10 seconds.
If there is no possibility to quickly remove faults, press
to arm the system.
Pressing
will cancel the arming process.
Note: Remove the causes of faults as soon as possible.
Error codes:
1 – Damage or disruption of detector
