31-7-2014 7 ebode IPV38P2P
1. LAN: 10/100 Mbps RJ-45 port for wired connection.
2. Power: DC 5V/2A Power supply.
3. Network Light: The LED will blink slowly in wired connection, blink two times faster in
wireless connection, blink four times faster when WPS.
4. Power Light: If the power supply works fine, the light will turn on.
5. WPS: Push the WPS button on the camera and wireless router in 1 minutes, the
camera will connect the wireless router automatically, in WPS process, the Network Light
will blink very fast.
6. SD card Slot: Supports up to 32GB SD card for storing the video.
7. Audio Output: This jack is used to plug an external speaker.
8. Audio Input: This jack is used to plug an external microphone.
9. Antenna: Used to connect external wireless antenna.
Bottom View
Figure 3.3
1. Mounting Port: Port for mounting bracket.
2. Reset Button: Push for more than 5 seconds to set the camera to factory default.
3. Product Label: Includes P2P QR code, MAC address, UID, DDNS URL, default username
and password.
4. Wi-Fi Module Label: Includes Wi-Fi MAC address and serial number of the Wi-Fi
module.
5. SN Label: There is serial number of the camera on the label
4. Access the IP Camera
This chapter explains how to access the camera through browser and RTSP player.
4.1 Access the Camera in LAN
This camera supports HTTP and HTTPS protocols, you can access the camera by two
ways.
(1) http:// LAN IP + HTTP Port NO.
The default HTTP port no is 88. Double click the IP Camera Tool icon to run, and it should
find the camera’s IP address automatically after you plug in the network cable.
