Tel 800 992 5013 / +1 508 234 6158
|
www.eaw.com
42
Line Array
Application Guide
The below example explains two cases in which you want to set a specified angle between two
modules using the rear rigging. Before carrying out any other operation, make sure that once
the movable arm is inserted [6], the hole of the chosen angle is contained inside the loop as
shown.
• FLOWN CASE:
insert only one pin in the hole on the chosen angle. The second pin can be
housed in the “PIN HOLDER” hole. Note that this type of configuration during the assembly
allows changing the chosen angle simply by moving the respective pin (with the movable
arm inserted).
• STACKED CASE:
once the pin [5] is inserted into the hole of the chosen angle, lift module
B as far as the movable arm [6] allows. At this point, insert the second pin into the “ANGLE
LOCK” position and release module B. This way, module B is completely blocked by the two
pins on the rear.
After assembly is completed, always make sure that all the pins have been completely inserted
and are locked.
Rear Rigging Assembly Plate