Tel 800 992 5013 / +1 508 234 6158
|
www.eaw.com
13
Line Array
Application Guide
SB818P|F Input Connection
SB818P|F utilizes a 2 pin +/- Phoenix connector. Using UXA4410, use NL4 with pins 1 +/- wired,
then connect the bare wire pins 1 +/- to the connector (which can then plug into the sub). If
multiple subs are being used, use the same NL4 connector and wire the pins 2 +/- and connect
pins 2 +/- to another Phoenix connector to then plug into additional subs. When using this type
of configuration, plug NL4 connectors into outputs 1 & 3 of UXA4410. It's possible to loop 1x
more cabinet using Loop Thru.
DSP
EQ
HPF
LPF
AMP
1-Way, Single-Amp (LF)
LF
LEGEND
DSP:
User-supplied Digital Signal Processor.
HPF:
High Pass Filter for crossover or specified High Pass Filter.
LPF:
Low Pass Filter for crossover.
LF/MF/HF:
Low Frequency / Mid Frequency / High Frequency.
AMP:
User-supplied Power Amplifier.
XVR:
Passive LPFs, HPFs, and EQ integral to the loudspeaker.
KF210 Input Connection
KF210 utilizes an NL4 connection with a switch for single or bi amped operation. When the
switch is in single amped mode, pin 1 only is utilzed. When in bi amped mode, pin 1 +/- is LF,
and pin 2 +/- is HF. When wiring to use with UXA4410 in single amp mode, plug NL4 into any
output on the amp, then directly into the cabinet (NOTE: Pin 2 +/- will be unused). When using
bi amp, plug into UXA4410 outputs 1 & 3, then directly into the cabinet. It's possible to loop 3x
more cabinets in either mode.