Bedingungen für die sichere
Verwendung (gesteuert durch
Eaton Zeichnung 464-1024)
25
10/13 MN03402007Z-DE/EN
• Alle Informationen, die mit beliebigen Feldausfällen dieses
Produktes verbunden sind, sollten im Rahmen eines
Management-Zuverlässigkeitsprozesses (z. B. IEC 60300-
3-2) gesammelt und an den Hersteller gemeldet werden.
• Die elektronischen Motorschutzrelais C440/XTOE/ZEB
dürfen nur in nichtexplosionsgefährdeten Bereichen
installiert werden, in denen die Installation zum EUC
erfolgen werden kann.
• Der DIP-Schalter „Reset“ darf nicht für eine automatische
Rückstellung konfiguriert werden (Stellung A), um einen
automatischen Wiederanlauf nach unklaren Fehlersitua-
tionen zu vermeiden. Die manuelle Rückstellung (Stellung
M) des Motorschutzrelais ist zwingend vorgegeben.
• Die Modbus-Kommunikation darf nicht zur Implementie-
rung der Sicherheitsfunktion verwendet werden oder zur
Implementierung der Sicherheitsfunktion über die Schnitt-
stelle zu einem verteilten Kommunikationssystem, wenn
das Sicherheitsgerät selbstversorgend ist oder eine
externe Versorgung benötigt.
• Das verwendete Leistungsschütz muss mindestens der
SIL1 Anforderung entsprechen. Alternative können Leis-
tungsschütze eingesetzt werden, deren SIL-Level unbe-
kannt ist, wenn die Anzahl der gefährlichen Ausfälle
l
DU
des Leistungsschützes nicht mehr als 5 x 10
-6
Ausfälle/Jahr
beträgt.
• Ein NOT-AUS Taster muss verwendet werden für den Fall,
dass die Sicherheitsfunktion des Produkts nicht reagiert.
• In Zusammenarbeit mit dem Hersteller muss der
Anwender/Installateur sicherstellen, dass der Bau der
endgültigen Installation sicher und die Auswahl der
Komponenten für den explosionsgefährdeten Bereich
akzeptabel ist. Siehe Zertifizierung SIRA 13ATEX9348X,
Abschnitt 17.8.