5
XSTORAGE HOME USER INTERFACE MANUAL
July 2019 www.eaton.com
Username
Default Password
Inverter Serial Number
Installer email
user
user
N/A
N/A
admin
jlwgK41G
Example: RB76H38084
Example:<[email protected]>
Default credentials for the end-user and Eaton certified installers are shown in Table 1.
Table 1: Default credentials for the end-users and Eaton certified installers
•
You can start the commissioning connected to the home internet network or the local router, via WiFi or an ethernet cable.
•
To connect via the ethernet cable, check that the xStorage Home system is listed below the right subnet as shown in Figure 9.
•
To connect via the WiFi local access point, use the following default SSID, password and IP address:
•
SSID: xstorage
•
Password: P4svFJA9
•
IP address: 192.168.3.99
3.2 Step 1: Network setting
s
•
Click on ‘Network settings’.
•
Fill in the form to proceed with the configuration of the communication card and the onboarding of the xStorage Home system.
•
If you use an ethernet cable, it is recommended to use DHCP (see Figure 2).
Figure 2: Network settings connection via an ethernet cable with DHCP
