Eaton XP-503, User Manual, Page: 21 / 70

4 Installation
4.4 Installing
XP-503
12/2014 MN048014-EN www.eaton.com
21
4.4.3 Mounting position
The device is designed to be built-in mounted in landscape mode.
It can be mounted in a perfectly vertical position or at an angle of up to ±10° in the directions shown
below.
If the device is not mounted in a perfectly vertical position, make sure that air will still be able to
circulate properly through the openings in the housing.
Example: XP-503-21
The following also applies to other device versions as applicable.
Abb. 2 Permissible mounting positions
4.4.4 Installation cut-out
The dimensions for the mounting cutout can be found in the"Fitting dimensions" section (for the
relevant device) of the "Mechanical dimensions" chapter

Make sure that there is also sufficient clearance for removing the XP-503 from the
mounting cutout.