7 Guidelines for station planning
7.7 Firmware download
XI/ON: XNE-GWBR-2ETH-IP
09/2011 MN05002007Z-EN
www.eaton.com
183
7.7
Firmware download
Firmware can only be downloaded via the service interface on the gateway using the software
tool I/O-ASSISTANT. It can not be downloaded via Ethernet.
More information is available in the program’s online help.
7.7.1
DIP-switch position
A firmware download to the gateway using the I/O-ASSISTANT, does not require a special
position of the DIP-switches. The described DIP-switch position can be used to "force" the
gateway into the download mode. This can be necessary, if the current supply was interrupted
during the download.
Attention
The station should be disconnected from the fieldbus when downloading.
Firmware must be downloaded by authorized personnel only.
The field level must be isolated.
Table 66:
Position of the
DIP-switches
for firmware
download
Address switch
Position
2
0
-2
6
0
2
7
1
MODE
1
CFG
1
Figure 72:
Position of the
DIP-switches
for firmware
download
