5
Assign a channel of the binary input in push button
mode
1. Press the configuration button on the binary input (the
mains supplied version requires a screwdriver) for
selecting the mode, push button mode is Mode 1, LED
flashes 1x for Mode 1
2. Press the configuration pushbutton with a screwdriver for less than 0.5 sec => actuator enters teach-in mode,
the LED in the actuator is on
3. Press pushbutton on the contacts of the binary input for less than 0.5 sec =>
4. The LED in the actuator flashes twice for confirmation
5. Press the configuration pushbutton with a screwdriver for less than 0.5 sec => actuator leaves teach-in mode
2. Unlink devices
Unlink an assigned pushbutton
1. Press the configuration pushbutton with a screwdriver
for less than 0.5 sec => actuator enters teach-in mode,
the LED in the actuator is on
2. Press the selected pushbutton until the LED has flashes 5 times
3. Press the configuration pushbutton with a screwdriver for less than 0.5 sec => actuator leaves teach-in mode
Unlink an assigned pushbutton on the remote control
1. Press the configuration pushbutton with a screwdriver
for less than 0.5 sec => actuator enters teach-in mode,
the LED in the actuator is on
2. Press the selected remote push button until the LED has flashed 5 times
3. Press the configuration pushbutton with a screwdriver for less than 0.5 sec => actuator leaves teach-in mode
Unlink an assigned room thermostat
1. Press the configuration pushbutton with a
screwdriver for less than 0.5 sec => actuator
enters teach-in mode, the LED in the actuator is on
2. Turn the control knob on the room thermostat to -
3. The LED in the actuator flashes 5 times for confirmation
4. Press the configuration pushbutton with a screwdriver for less than 0.5 sec => actuator leaves teach-in mode
Unlink an assigned channel of the binary input in
switch mode
1. Press the configuration pushbutton with a screwdriver for less than 0.5 sec => actuator enters teach-in mode, the
LED in the actuator is on
2. Open contact of the binary input
3. Wait until the LED in the actuator has flashed 5 times
4. Press the configuration pushbutton with a screwdriver for less than 0.5 sec => actuator leaves teach-in mode
Unlink an assigned channel of the binary input in
push button mode
1. Press the configuration pushbutton with a screwdriver for less than 0.5 sec => actuator enters teach-in mode, the
LED in the actuator is on
2. Press pushbutton on the contact of the binary input until LED has flashed 5 times
3. Press the configuration pushbutton with a screwdriver for less than 0.5 sec => actuator leaves teach-in mode
