background image

1.3.  General provisions 

  The UM15 unit may only be used for specific applications. Any application beyond this 

shall be deemed not to be in accordance with the intended purpose. EATON 

Technologies GmbH accepts no liability for damage resulting from improper use. 

  All operators must read and understand this manual before commissioning the unit. 

Changes to the system may only be made with the express permission of EATON 

Technologies GmbH.  

  For damage caused by: 

o

  Failure to observe these operating instructions 

o

  Failure of due diligence during transport, installation and operation 

o

  Improper repair 

o

  Failure to maintain the unit 

 

EATON Technologies GmbH assumes no liability. 

  We reserve the right to make design changes to the system. The contents of these 

operating and maintenance instructions are subject to change without notice. 

 

 

1.4.  Intended use 

The UM15 circulating filter units are mobile filter units corresponding to the technical 

parameters of the 4019 data sheets. They are intended for the fine filtration of hydraulic oil 

based on mineral oil and for extracting water from such fluids. 

The UM15 circulating filter units remove oil from a container connected via a hose line in 

order to clean it of dirt and water. The cleaned oil is pumped into the designated container. 

The foreign matter accumulates in the filter. The device must be supervised during 

operation. 

The maximum permissible size of dirt particles in the operating fluid should be < 200 µm. 

Larger dirt particles will cause premature wear of the gear pump. 

 

 

 

1.5.  Areas of application—compatibility 

 

The UM15 units are only suitable for operation on hydraulic and lubricating oil systems 

within the following operating limits: 

  Hydraulic oils (H, HL, HLP, HLPD, HV) 

  Natural esters (HETG) 

  Synthetic esters (HEES) 

  Gearbox oils (C, CL, CLP) 

 

NBR (Perbunan) is used as a sealing material! 

 

 

 

 

 

 

 

 

 

 

Summary of Contents for UM15










Reviews: