19
©2015 Eaton Corporation
All rights reserved
REC Series Enclosure Installation Guide _issue 4
Installation Guide
Step – 3
Referring to the images on
page 18, assemble the frame
uprights (items 1 & 2) to the
frame cross beam (item 3)
using 4 off M6 x 16mm screws
(item 7).
Step – 5
Fit the brush (Item 12) to
the brush carrier on the
door bottom by pushing it
into place (this is easier be-
fore doors are hung).
=
Hinge half with
pin to be fitted
to frame upright.
(Right hand
hinge shown).
10
12
Step – 4
Fit the hinges (item 9) to the
frame uprights (items 1 & 2)
using M5 x 8mm screws (item
10) shown in image below;
Note the hinges are handed
Left or Right . Fit hinges to
corresponding door.
42U Height;
Fit 42U Top Panel (item 4) to frame uprights using 2 off M6 x 16mm screws
(item 7). Discard Item 5 and Item 6.
47U Height;
Fit 47U Top Panel (item5) to frame uprights using 2 off M6 x 16 screws
(item 7) and to Cross Beam (item 3) using 2 screws (item 7). Fit Back Fill Panel (item 6)
to rear of Top Panel (item 4) using 2 off screws (item 7) and 2 off M6 Cage Nuts (item 8).
Discard Item 4.
7
Tip: This is best done with the components
laid flat on a level floor.
2
(1 = LH Vertical)
3
