Chapter 6—Installation Requirements
DG1 Series VFD
MN040002EN—March 2014
www.eaton.com
33
Figure 19. Ground Wiring
Note:
Do not wire motor leads to R+, R–. This will cause damage to the drive.
Note:
Actual layout may vary slightly by frame.
Ground Wiring
●
Run motor cables in separate conduit
●
DO NOT RUN CONTROL WIRES in same conduit
●
Cables sized per
Appendix B
●
Provide
dedicated
wire for low impedance ground
between drive and motor. DO NOT USE conduit as ground
CAUTION
Improper grounding could result in damage to the motor and/
or drive and could void warranty.
Control Wiring
7.
Wire the control terminals following the details for the
specific option boards shown on the following pages.
Note:
For ease of access, the board terminals blocks can be
unplugged for wiring.
8.
Wire control to the control board.
Note:
Drive default is programmed for external interlock.
Summary of Contents for PowerXL DG1-323D7FB-C21C
Page 1: ...PowerXL DG1 Series VFD Installation Manual Effective March 2014 New Information...
Page 2: ......
Page 83: ......