Commissioning
28
09/10 MN05013011Z-EN
As soon as you connect the display/operator system to the
device (e.g. easy800 or easySafety) via a connection cable
and switch it on, it will try to establish a connection to this
connected device, due to the preset NET-ID.
If the connected device is a single device, a 0 must be
entered in the display/operator system as the station ID.
The connection cannot be established if another number is
entered.
If the connected device is a station on the easyNet, the
display/operator system connects to the easyNet station with
the station ID entered in the display/operator system:
If ID = 0 is entered, the connection is made to the device
(e.g. easy800 or easySafety) that is connected to the display
operator system via the connection cable – irrespective of its
NET-ID.
Entering a new station ID connects the display/operator
system with the selected station.
As soon as the connection is established, the display/oper-
ator system is in Terminal mode. In this mode, it takes on the
information of the device display and shows it on the display
of the display/operator system.
You only set the baud rate on the display/operator system.
The connected device will adapt itself automatically!
Connection
establishme
nt
in progress...
h
The connection is not possible if the selected easyNet
station is an easySafety device.
