FITTINGAN MCB/RCBO
When fitting an RCBO, trim RCBO ‘N’ cable to length
and connect to ‘N’ busbar terminal.
Connect load live/neutral cable direct to RCBO.
TIGHTEN TERMINAL SCREWS TO 2.4 Nm .
All unused w ays
must be fitted w ith
a blanking module,
assembled and
fitted in gangs of 3.
Before fitting
to busbar
ensure MCB
terminal is
fully open
IMPORTANT:
Orientate MCB clip next
to busbar stack
Locate and
tighten terminal
screw s to 2.4Nm
Clip fit
Remove thin area (shaded)
inside shield to allow
link to be fitted
FITTING SINGLE PHASE ?
Ensure both
neutral shields
are fitted after
installation
WARN IN G
SHORTING BAR FITTED
Fit cover w ith label
Single
phasing
link
Tighten
terminal
screws to
15Nm
