2
EATON
IB506017EN
Installation instructions
Installation Instructions – Tracer (Small / Large)
Tools Required
Phillips head screw driver and electrical wiring tools.
1-1/16 Inch (27mm) crowfoot wrench.
otee:
N
This configuration is equipped with an adjustable
knuckle which can be mounted directly to the 1/2”
NPS access hole in the cover plate of the junction
box.
1. Loosen the knuckle center screw with phillips head
screw driver. Adjust the position and angle of the
knuckle stem. Re-tighten the center screw to 9 in-lbs
for Tracer Small or 17 in-lbs for Tracer Large. (Figure 1.)
Figure 1.
Figure 2.
Fixture
Black
White
Green
Violet
Grey
(+) Line
Snoot Visor
(Included)
Flat Visor
(Installed)
(-) Common
Ground
Dim +
Dim -
2. Route electrical leads through the 1/2” NPS access
hole in cover plate (supplied by others). Secure knuckle
to cover plate with lock nut. Adjust aiming angle of the
fixture by loosening the lock nut. Re-tighten the lock nut
to the cover plate at 48 in-lbs using a crowfoot wrench.
(Figure 2.)
otee:
N
Installer must apply silicone compound around entire
perimeter of the 1/2” NPS threads where it mates to
the mounting surface. This will create a water tight
seal between the fixture threads and the mounting
surface.
3. Make wire connection in outdoor rated junction box.
Use wire nuts or other approved connectors to wire
fixture per wiring diagram. (Figure 3.)
otee:
N
Mounting the cover plate to the junction box and
then screwing the knuckle of the luminaire into the
cover plate can result in the twisting the wires,
causing connections to break and creating a shock
hazard when power is turned on.
4. Push wires into junction box and install cover plate
(with luminaire attached) to the junction box.
otee:
N
Ensure wires do not get pinched.
Snoot Visor Installation
To change the visor, unscrew the phillips 4-40 screws
holding the flat visor. Replace visor with snoot visor and
align the arrow on the visor downwards. Insert the phillips
4-40 screws into the visor screw holes and tighten until
visor is secure. Tighten/torque to 8 in-lbs. (Figure 4.)
Figure 3.
Figure 4.
