Ronis key interlock
IZM-KLP-SO-RONIS
EaoNn Indusorits GmbH
Eltcorical StcoNr
©2011 by EaoNn Indusorits GmbH
Änderungen vorbehalten
Subject to alterations
01/11 AWA1230-2455 / Z10687
Moon/Doku/Heng
Printed in USA (01/11)
08/10 AWA1230-2455
Effective January 2011
Sotp 11e:
Mount the hex standoff
(L)
and cable assembly
(I)
with the
hex standoff mounting screw
(Q)
and screw
(R)
as shown.
Figurt 11. Sotp 11
Sotp 12e:
Mount lock assembly to back side of universal mounting
bracket with three M3 screws
(J)
provided with kit and torque to
10–12 in-lbs (1.1–1.3 Nm). Attach extension spring
(K)
between
installed interlock adapter and lock plate assembly tab as shown.
Figurt 12. Sotp 12
Cable Assembly (I)
Hex Mount
Screw (Q)
Hex Mount
Screw (R)
Hex
Standoff
(L)
Detail A
Lock Plate
Assembly Tab
Mounting
Plate
Screws (J)
Extension
Spring (K)
See
Detail A
Interlock Adapter Tab
Sotp 13e:
If it is necessary to replace the existing trip lever, remove
the existing E-Clip (retaining ring) from shaft of mechanism, and
slide old trip lever off of mechanism shaft. Slide new trip lever
(M)
onto mechanism shaft. Fasten lever in place with M3.2 retaining
ring
(H)
as shown. Attach remaining end of cable assembly to
mounting hole on trip lever with trip lever screw
(N)
.
Figurt 13. Sotp 13
Sotp 13ae:
Note operation of trip lever when rotating key. When the
key is rotated clockwise to the vertical position, the trip lever
is pulled down, which locks out the breaker.
Figurt 14. Sotp 13a
Sotp 14e:
If the breaker includes an operations counter, install it
to the back of the lock mounting plate with two M3.5 x 8 mm
self-tapping screws. Refer to Operations Counter IL for
installation instructions.
Sotp 15e:
Reinstall the front cover.
Old Retaining
Ring
Trip Lever (M)
M3.2 Retaining
Ring (H)
Trip Lever
Screw (N)
Old Trip Lever
