Eaton i-on16, Administrator'S And User Manual

Page: 62 / 92

4. Administration i-on16
Page 56
6. Press

until you see:


7. Press

.
The bottom line of the display
shows the first in a list of the
outputs allocated for your use.
If the output has a name
programmed for it, that will appear
on the bottom line instead of the
output number.


8. Press

or

to display the output
you wish to test.


a). Press

.
The keypad gives a double “beep”
confirmation tone. The keypad
display shows:
The control unit turns on the output.
Check that that it is working as
expected.
Note: Outputs connected to radio output
modules may take several
seconds to change state.


b) Press

again to turn the output
off.


9. Press

to end the test.


NOTE: Make sure no one tries to activate an output by means of a remote
control while you perform the test.
When you complete the test check that the output is back in the
state it had before testing. For example, if the output was off before
testing, make sure it is off after testing.