Eaton G110 Series, Installation Manual

Page: 8 / 45

Before you Begin
Tools you Will Need
The following tools are required to successfully install the workstation.

Common installation tools

3/8” socket

TORX driver for M8x36 flathead screws

#1 and #2 Phillips head screwdriver

Powered driver

Spirit (bubble) level

Hole saw, 2-1/2” diameter

11/16” nut driver (or socket wrench)

5/8” nut driver (or socket wrench)

5/32” Allen wrench

1-3/8” open end wrench (for leveling glide adjustment)

Phillips head screwdriver

Rubber mallet
Fasteners you Will Be Using
Following is an illustration of the fasteners and screws that are provided in the Lift assembly box
(provided in kit labeled PROKIT43-thru-PROKIT46). Front and side views are shown. For a
complete list of parts, refer the section, “Unpack the Box Contents” in Chapter 2.
Item Description
Part
Number
Screws
3 #8-32 x 3/8” flathead, thread
cutting screw 18618
8 Pan head thread form screw
#10-32 x 3/8” 66714
12 M6 x 10mm Phillips pan head
screw 91503
10 1/4-20 x 1/2” pan head screw 83105
15 Phillips pan head screw 97409
5 1/4-20 x 1/2” hex washer thread
form 54348
14 Phillips pan head screw 97408
11 M6 x 20MM Phillips pan head
screw 85234
7 #10A x 1” Phillips pan head
screw 62071
17 M8x36 flathead Torx (supplied
with DL2 by LINAK) N/A
16 Hex head, 3/8-16 x 2.5” bolt 98129
Front View Side View
www.eaton.com/powerquality 11-41 06-2011 Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation
2