Installing the Ergonomic Workstation
Attach Workstation Support
Follow these instructions and refer to the illustration below to attach the workstation support to the
assembled components.
CAUTION:
To prevent personal injury and product damage, two or more people are required to
perform the following procedure.
1. Align the workstation support over the left and right leg assemblies.
2. Using four lock washers (18950) and four Phillips head screws (91503) per side
two sets in the
front and two sets in the rear
loosely attach the support to the top of each leg.
Step
(4x)
Step
Step
Step
Step
Detail Shown
3. Level the support, then align to the top of each leg and tighten the eight (8) screws that were
inserted in step 2. See illustration above.
19
Eaton Profile Genesys Dual-Lift Ergonomic Workstation Installation
wwww.eaton.com/powerquality 11-41 06-2011