13
Installation and operation manual for
conventional fire panels
EATON
www.eaton.com
•
To remove the PSE PCB from the back box unplug the cables
from the main board as shown in Figure 15
•
Then simply remove the screw and push the PCB up, to the
right and forwards as shown in Figure 16 .
•
Once the cable entry holes have been cut then fit the cable
glands to the back box .
•
If the panel is being flush mounted, then insert the panel into
the recess feeding the cables through the rear cable entry
points .
Figure 15. Disconnect the PSE
Figure 16. Remove the PSE
Technical Data
25-16733-A
Effective
October 2019
