INSTALLATION INSTRUCTIONS
10
WIRING - GENERAL
1. Disconnect all power before wiring terminals.
2. Do not use machine power service for 115/230
VAC input power to the control. A dedicated or
lighting circuit is recommended.
3. Keep all signal lines as short as possible.
4. Do not bundle or route signal line(s) with
power carrying lines.
5. Tools required are a wire stripper and a small
common screwdriver.
6. Refer to the setup chart Figure 6 for terminal
designations.
7. Use 18 ga. Minimum (1mm
2
, 600V) and 14 ga.
Maximum (2.1mm
2
, 600V) wire for AC power
wiring.
8. See Figure 8 for correct fuse to be used in the
power input wiring.
Figure 6.
Terminal Designations
