4.1
Disassembly/Inspection
NOTE: Item numbers ( ) shown on Figure 1.
4.1.1
Remove the four screws (5) from the cover
(3) and the four screws that retain the split
ring (4). Remove the cover.
4.1.2
Remove the "J" Cups (9) from the cover.
4.1.3
Remove the housing (1) from the rotor (2).
4.1.4
Remove the "J" Cups (8) from the housing.
4.1.5
Thoroughly clean all parts using any
commercial cleaning solvent.
Follow manufacturers recommended
safety precautions when using
cleaning solvents.
4.1.6
Inspect the machined surfaces of the housing
and rotor for scratched or damaged surfaces.
4.1.7
Replace any worn parts.
4.2
Assembly Procedures
4.2.1
The following general assembly notes should
be followed carefully to assure a properly
repaired rotorseal. NOTE: Replace all "J"
Cups when rebuilding the rotorseal.
4.2.2
All repairs should be made in a clean, dust free
environment.
4.2.3
Pack the "J" Cups (8) with synthetic base
grease and install into the housing bore noting
the orientation of the seal. See Figure 3.
4.2.4
Lightly lube the O.D. of the rotorseal, and slide
the housing over the rotor (2) taking care not to
damage the "J" Cups.
4.2.5
Install new "J" Cups (9) onto the cover boss.
See Figure 4 for proper orientation.
4.2.6
Install the cover onto the housing, taking care
not to damage the "J" Cups.
4.2.7
Using removable liquid threadlock, install the
screws (5) and torque to 60-70 in.-lb..
4.2.8
Reinstall per section 2.0
5.0
ORDERING INFORMATION
AND TECHNICAL ASSISTANCE
5.1
For further information or assistance, call or
write:
Eaton Corporation
Airflex Division
9919 Clinton Road
Cleveland, Ohio 44144
Ph: (216) 281-2211
Toll free: (800) 233-5890
FAX: (216) 281-3890
Figure 3
Figure 4
RS 9210 (PDF Format)
5
® Copyright Eaton Corp., 2004. All rights reserved.
December, 2004
