INSTALLATION
Eaton 9910 UPS and EBM Installation Guide (6000 VA Models)
S
P-164000007 Rev 1
26
19.
Slide the battery retaining bracket [1] to the left into the slot, as
shown in Figure 12.
20.
Rotate the bracket toward the UPS [2]. Verify that the internal
battery connectors are out of the way.
21.
Slide the bracket to the right [3]. Tighten the thumbscrew [4] on the
bracket. Torque the screw to 0.7 Nm (6.2 lb in) if using a torque
wrench.
22.
Connect each internal battery connector [5] and attach the
connectors to the battery retaining bracket between the studs.
NOTE
A small amount of arcing might occur when you connect the batteries. This is
normal and does not damage the unit or present any safety concern. Push the two connectors
together firmly until fully seated.
Figure 12. Securing and Connecting the Batteries