2
GFX Manual
EATON
GFX Installation and Operation Manual April 2020 www.eaton.com
CAN
Controller Area Network
EMC
Electromagnetic Compatibility
FCC
Federal Communications Commission
GNSS
Global Navigation Satellite System
GPS
Global Positioning System
IMU
Inertial Measurement Unit
IP
Ingress Protection
NMEA
National Marine Electronics Association
RED
Radio Equipment Directive
SAE
Society of Automotive Engineers
PWM
Pulse Width Modulation
Key acronyms and abbreviations:
Mechanical
Size
L 125mm x W 43mm x H 22.25mm (Length x Width x Height)
Weight
160 gram
Mounting torque
1.8Nm±0.2Nm
Mounting size
5.35mm hole
2 locations
Color
RAL 9005 Jet black
Potted assembly
Technical specifications:
GPS specification
GPS L1 frequency
1575.42 MHz
Accuracy
4.77m CEP
Circular Error Probability
(radius of a circle centered on
the true value)
Acquisition time
Hot start 4 Sec
Warm start 38 Sec
Cold start 60 Sec
Sensitivity
Tracking -160dBm
Acquisition -145dBm
GPS data update rate
5Hz
IMU specification
Linear acceleration
±4 g
Angular rate
±245 dps
Magnetic field
±4 gauss
IMU data update rate
50Hz
Operating voltage & input current
Operating voltage
5VDC to 36VDC
Vehicle battery operated
Nominal voltage
12VDC and 24VDC
Input current
Up to 120mA
At full operating voltage range
Overview:
The GFX sensor is a high-performance GPS and dynamic motion
sensor for use in on/off-highway vehicle applications. The unit
features an embedded GPS receiver and inertial measurement unit
(IMU) sensor with configurable outputs to meet the needs of a
variety of demanding applications.
Model Part No. 6044572-001
•
GPS receiver provides positioning and velocity estimates at 5Hz
•
NMEA 2000 (CAN) and NMEA 0183 (RS232) output messaging
•
Provides ISOBUS ground speed message
•
Available true ground speed PWM output (available on request)
•
IMU provides 3-axis: linear acceleration, angular rate and
magnetic field
•
Low current consumption (up to 120mA)
•
Wide operating temperature range (-40°C to 85°C)
•
Dustproof and waterproof design, suitable for open-cab
environments
•
Compact and rugged package allows for flexible vehicle mounting
•
Easy to install and use
X, Y & Z axis
Direction of detectable accelerations
Direction of detectable angular rates
Circular arrow direction indicates positive angular rate
Digital speed output
Signal format
PWM
Duty cycle: 77%
PWM frequency
36Hz to 1.85KHz for 1kph to 50kph speed
Linearly varying
Signal amplitude
Equal to supply input
Accuracy
± 5%
Source impedance
100Ω ± 10Ω
Load impedance
>3kΩ
otee:
N
1. Digital speed output is disabled at speed less than 1Kph
2. When digital speed output is disabled, output will be equal to supply input
(100% duty cycle).
Cautione:
Pay attention to Digital Output Pin Wiring. This pin should not be short
circuit with ground terminal.
Key features: