Location & Mounting of Outdoor Unit (ICU)
Location
The unit can either be mounted on a level surface or suspended from a vertical wall using the Qualitair wall mounting Optional kit (1).
The unit should always be mounted on a load bearing wall and not a partition wall. Ensure there is sufficient free area around the unit
as shown above.
Fixing
Two off hole fixings (2) and two off slot fixings (3) suitable for M10 fixings are provided in the base of the unit to secure the unit to a
suitable plinth, or to the wall mounting bracket kit. If required, the contractor should install the unit on anti - vibration pads.
Service Connections
The refrigerant pipe (4) and electrical connections (5) are located at the right hand end of the unit, and the condensate drain for the
heat pump unit is located on the base of the unit.
Air Entry
Ensure there is adequate air entry at the back of the unit as detailed above.
SPECIAL NOTES :
ENSURE CONDENSER HAS ADEQUATE CLEARANCE AROUND IT AND IS NOT AFFECTED BY NEIGHBOURING
CONDENSING UNITS.
Eaton-Williams
Low Temperature DX Cassette
Page 8
QLC/ICU
Document 0412124
Issue 2.1 05/06
130
min.
600 min
.
1
2
3
4
5
AIR IN
CONDENSATE
DRAIN
600mm
min.
1
3
0
m
m
m
in
.
1
0
0
0
m
m
m
in
.
z
Y
ICU40
ICU55
ICU80
Width mm
720
800
800
Height mm
610
765
765
Depth mm
250
320
320
Weight kg
42
60
64
Dim ‘Y’ mm
220
290
290
Dim ‘Z’ mm
670
750
750
Indoor Unit
QLC10
QLC15
QLC20
ICU Unit Positioning
ICU Wall Bracket Fixing
ICU Wall Bracket Fixing
290
z
unit level
