5
4
TROUBLESHOOTING
PROBLEM
SOLUTION
Scale is inaccurate or weight varies
Place feet in center of scale platform and stand still. Allow
weight to lock in before looking down at display.
Flooring may be reason for fluctuation. Use on the
hardest floor available for best accuracy.
Scale displays “
Lo
” for low battery
No power
Check batteries for proper installation (polarities are
correct). Replace all worn batteries.
Problem persists or other conditions
Call Eat Smart for support at 866-843-3905 (8 to 5 MST).
CARE & MAINTINANCE
To protect and maintain your EatSmart bathroom scale in the best
possible condition follow these directions as closely as possible.
1. Store and operate the unit in a safe dry location.
Drastic changes in temperature over time can affect the quality of
weight measurement. Do not expose to direct sunlight, extreme hot/
cold or high humidity.
2. Clean with a damp, soft cloth.
Avoid abrasive cleaners and never sink
or submerge in water.
3. Remove batteries if not in use for three months or longer.
4. Do not store scale where you store cleaning chemicals.
The vapors
from some household products may affect the electronic components
of your scale. Do not store scale on its side.
5.
This scale is designed to read weights between 11 and 330 lbs / 5 and
149.6 kgs / 11lb and 23st 8lb. To prevent damage, do not place more
than 330 lbs / 149.6 kgs / 23st 8lb on it.
6. Use unit consistent with instructions provided in this manual.
Weighing Operation
Your EatSmart Bathroom Scale operates as a basic body
weighing scale. No special programming is required.
1. Select your desired measurement unit.
Your scale has
been set at the factory to read weight in pounds. You can
switch to kilograms or stones units of measurement by
pressing the “
Kg/Lb/St
” button on the bottom of the scale.
2. Place the scale on a hard, flat surface.
Carpeted, uneven
or cushioned flooring can negatively affect the accuracy of the
reading.
3. Initialize the scale.
(if needed, see page 3, steps 4-6).
4. Step on.
Place both feet on the center of the platform and
stand still.
5. Your weight will appear on the digital display.
Your
weight will blink when your final weight has been
calculated.
6. Step off the scale.
It will reset to "
0.0
" turn off
automatically.
Important:
Your EatSmart scale operates with "
Step-On
"
technology but still needs to be auto-calibrated after battery
installation or after the scale is moved, to ensure accuracy.
Overload indicated “
Err
”
Too much weight has been placed on the scale and it is
overcapacity. Remove weight before proceeding.
First weight is higher than normal
Your scale must be allowed to auto-calibrate. Follow
instructions under “Operation” for proper use.
