FIG . 5- To adjust the height of the glide handles, loosen ratchet clamps. Adjust the handles to the
user’s desired position and tighten the clamps securely.
The resistance cylinders are individually adjustable to provide twelve different resistance settings. Turn
the cap of the cylinders to the desired resistance. The resistance cylinders can also be disconnected
by disengaging the pull pin.
FIG . 6- Adjust the foot plates by loosening the two knobs on each foot plate (for easier access to the
inside knob, swing the leg assembly forward), so the user’s knees are centered in the knee pads and
the femur is resting on the seat. Tighten securely.
Caution: Never reposition the foot plates while a user is in the standing position.
Caution: Avoid placing fingers in the adjustment slot.
FIG . 7- Often, proper fit can be achieved by adjusting the foot plate height. When necessary, the knee
pads are independently adjustable with five adjustments. To adjust the knee pads, remove the bolts
from the knee pads and adjust to the desired position. Replace the bolts and tighten securely.
FIG . 8- Before transferring, flip up the knee pads to allow easier access.
Caution: Never make adjustments to the EasyStand while a user is in the standing position.
Caution: While using the Glider, advise bystanders to keep hands and feet clear of the Glider
mechanism.
Caution: While using the Glider, keep hands clear of the resistance cylinders’ upper and lower
mounting points.
FIG. 5
FIG. 7
Adjustments
FIG. 8
!
!
!
FIG. 6
Page 19 - Perfect Fit Guide
Adjustments - Page 4
Perfect Fit Guide
!
!
step one - measure
Before transferring into the Glider, measure for
approximate (A) seat depth and seat to (B) foot plate
settings.
Caution: These adjustments are only to be made while the
unit is unoccupied.
step two - seat depth
To adjust seat depth, loosen the knob under the
seat (C). Use measurement (A) and measure from
the inside of the knee pad to the back. Depress the
snap button on the adjustment tube while moving
the back (D). Adjust the seat depth until the proper
measurement has been reached. Tighten the knob
(C) after adjusting.
Caution: The following adjustments are only to be made in
the seated position
step three - back angle
After achieving the desired seat depth, rotate the
back angle (E) adjustment knob so the (F) seat/back
angle indicator on the side of the unit is in the green
area prior to standing.
Note: Repeat steps 2 and 3 for each color adjustment.
step four - foot plates
Use the (B) measurement to adjust the foot plate
height. Loosen the (G) knobs on the foot plates to
adjust height. Tighten the knobs after positioning.
The knees should be slightly lower than the hip (H).
step five - positioning
Position the user’s hips as close as possible to (I)
Glider’s hip pivot.
step six - knee pad
Slide into knee pads (J) and secure the calf straps
behind the knees.
(C)
(D)
(B)
(A)
(F)
(E)
(G)
(H)
(I)
(J)
Inspect your standing frame periodically to ensure it is in safe operating condition.
!
!