page 33
page 6
EasyStand Evolv Assembly
FIG. 5
FIG. 4
Evolv E3
Spacer
If the Swing-Away Front was ordered, please refer to pp. 7-8.
If the Independent Kneepads were ordered refer to p. 25.
FIG . 4- Remove ratchet handle and hardware from the knee
bracket. Place the bracket and hardware onto the column in
the order shown. Ensure the spacer is placed between the
two steel brackets. Place the washer and bracket bolt into
the bracket assembly and tighten snug, ensuring the knee
bracket moves freely. Do NOT overtighten bolt. Place the
washer and ratchet handle into the bracket assembly. Tighten
ratchet handle once desired position is reached.
Remove the three bolts from the kneepad making sure the
plastic insert stays in place. Place the kneepad onto the
bracket and insert top two bolts before inserting the middle
bolt. Tighten securely. If the independent kneepads were
ordered, place pads into knee bracket, make sure the larger
end of the pad is on the outside of the unit (see drawing on
p. 25).
If the Shadow Tray was ordered, please refer to pp. 9-10.
FIG . 5- Insert the tray post into the front column with the
holes in the post facing upward. The tray clamp on the front
frame may need to be adjusted to fit the tray post into the
frame. Place tray onto the tray post, insert nut into slot and
bolt into hole, tighten securely.
If any additional options were ordered, please refer to the
drawings on pp. 18-26.
FIG . 6- Install the seat onto the seat assembly after all other
options are added. For easier installation, pump the seat half-
way up. Start all four bolts first, then tighten
securely.
For Evolv adjustments, see pp . 27-30 .
Evolv Options & Parts Detail (rear)
