LED Light Kit Assembly Instructions
for 1/2 to 1 hp Kasco VFX, AF and JF Series Units
1. Attach the light fixture to the supplied brackets. The nylock nut
comes attached to the bracket for shipping. You will need to
remove nylock nut and install the yoke of the light fixture to the
bracket. Run the pig tail as shown in Figure 1. Secure the light
fixture with nylock nut. A three light set can be attached as you
see in Figure 2; the arrows indicate where you would attach a
two light kit (recommended only up to 3/4 hp units).
2. For Kasco units use the hardware pack labelled LKH-KBW
with shorter bolts and smaller washer. Put bolt through the
bottom of the bracket in the hole closest to the light.
Then line it up in holes on float and secure to float with washer
and nylock nut on top of float. Do not overtighten; simply make
sure it is snug and secure. Some movement of the bracket will
not affect quality of lighting.
3. Connect pigtails to cord splitter (two or three x 1 depending
on kit). To do this, be sure the pigtails go around the motor
screen in an orderly way so all lights can be connected without
twisting. When connecting cords, be sure the o-ring is present
in the female portion of the connectors. (Figure 3) Push pigtails
into splitter and secure with 1/2 turn quick connect nut on
splitter. (Figure 4)
4. Connect main cord to the remaining end of the splitter section.
Be sure the o-ring is present (Figure 3) and secure cords with
1/2 turn quick connect nut. (Figure 4) Multiple cords can be
connected up to 300’ long between the light fixtures and the
control unit.
5. The main cord MUST BE SECURED to the float of the
fountain. Use the plastic cable ties included in your kit to do
this. This acts as a strain relief for the cords.
6. Adjust the angle of the light fixtures based on the spray pattern
being used. Tip in toward center for narrower pattern and tip
out slightly for wider pattern.
7. Plug the main cable into the pigtail of the mounted controller
unit. Be sure to mount the weatherproof controller with timer in a secure location near a power
supply and plug into 115 volt outlet. See “Setting the Timer” for detailed instructions on the
controller.
8. Over time the LED lights may appear dimmer than when new. This is caused by algae or
sediment on light lens. This can easily be removed with a small brush (a toothbrush works great).
4
Figure 4
Figure 1
Figure 2
Figure 3
o-ring
