9
5. Ensure that as the film is being
drawn over the rollers it is smooth.
If it isnt you can apply tension to the
film mandrel by turning the core grip
adjustment sleeve apply just enough
pressure to remove any airpockets or
creases
6. Your document can now be
fed into the laminator. Place the
document flat on the feed table and
push it towards the nip of the rollers
Laminating - SINGLE HOT
1. The single heated Easymount can
be run either cold or warm to switch
between the two modes press the
hot roller button on the control panel
The display will then show HOT next
to the top roller icon
2. Set the temperature to
approximately 40°C/104°F using
the up or down buttons. Both the
set temperature and the actual
temperature are displayed.
3. Plug in the foot pedal
5. The films will then begin to be
drawn through the machine.
NOTE: When using continuous mode
if the ‘magic eye’ sensor is blocked by
material or hands the machine will
stop - to over ride the sensor press
the foot pedal
6. You can adjust the rate at which
the machine laminates by turning
the ‘speed control knob’
4. To drive the machine press either
the drive button (left hand arrow)
continuous drive or step button
(middle arrow) for the foot switch.
The foot switch over rides the
magic eye, it is advisable to start the
machine & then press the continuous
button when running
