11
Take Up Unit
1. To fit remove blanking plates from
rear of the machine
3. Fit the other bracket in place of the
right hand blanking plate
2. Fit motorized bracket in place of
the blanking bracket - left hand side
looking from the rear of the machine
6. Fit the take up mandrel (note
the bracket is sprung loaded on
the unmotorised unit). Then using
double sided tape attach media/
laminate to the core, the Easymount
laminator is now ready to run prints
reel to reel.
5. Put a spare core onto the take up
mandrel
Laminating adjustments
Temperature
Most pressure sensitive films benefit from around 40°C / 104°F of heat being applied to help elliminate ‘silvering’. If you dont
get the desired result with 40°C / 104°F continue adding 5°C / 41°F of heat until you get the finish required.
Speed
Adjust the speed until you get the required results
Roller Pressure
Under normal operation wind the roller pressure adjustment handle until the rollers meet and the handle goes into a neutral
mode then turn gently until you feel resistance. Then just apply an extra
1
/
8
of a turn to ensure there is sufficient pressure.
If ‘BOW’ marks appear across the laminated document there is too much roller pressure applied and the top roller should be
lifted slightly.
4. Plug in the take up unit
