AFTER SALES SUPPORT
1 888 367 7373
10-29-14 / EE-3186A
NOTE: The water level sensor is made of three key parts. When cleaning DO NOT MISPLACE these
parts and MAKE SURE that you assemble these three parts correctly after cleaning and before
operating humidifier. They are as follows:
Plastic Cap – this part has 4 flat tabs coming out from the bottom and is placed
on top of a plastic pin
Water Float - a small round part resembling a “life saver” candy located
underneath the Plastic Cap
Pin – plastic pin that secures water float and plastic cap
To clean the water float unscrew the plastic cap from the pin. Remove the water
float and clean by wiping the parts with a soft damp cloth. Replace the parts by
first putting the water float onto the pin and re-screwing the plastic cap onto pin.
STORING
Allow the humidifier to dry completely before storing. Store the humidifier in a dry location. Do
not place any heavy items on top of humidifier during storage as this may result in possible
damage of the appliance. Always check the plug before use to assure metal items have not
become attached.
STORING YOUR HUMIDIFIER
Save the box for off-season storage.
Make sure the tank, water basin and water tank cap are thoroughly dry before storing.
If water is left in the unit during storage, it may evaporate completely and leave deposits that
can prevent the unit from operating properly.
Leave the water tank refill cap loose to prevent the water cap and gasket from sticking
together. This will prolong the life of the gasket.
12
