AFTER SALES SUPPORT
1 888 367 7373
10-29-14 / EE-3186A
7.
Plug the power cord into a wall socket (do not
use extension cord) and turn on the unit by
turning the control knob. (see Fig. 10)
8.
The Power Light will turn on red. In a few seconds it will switch to green,
indicating that enough water is in the water basin, and mist will start emitting
through the openings at water tank lid.
9.
Use the humidity output regulator control knob to
adjust the intensity of the mist output. Turning the
knob clockwise will increase the moisture output,
turning the knob counterclockwise with reduce
the moisture output. (see Fig. 10) Note: When at
maximum level it is normal to hear a faint
dripping sound.
Fig. 10
10.
When the humidifier runs out of water the power light will turn red, and the mist output will stop.
This is a safety feature to prevent the humidifier from possibly over heating and damaging the
nebulizer. This safety feature uses a water level sensor to stop the nebulizer once the water level
sinks below the required level in the water basin. Turn the humidifier off and unplug before
removing and refilling the water tank. Please note that the Power Light on the humidifier body
will stay on. The (red) light signal indicates that the humidifier is turned on and needs to be
refilled.
SET THE CORRECT HUMIDITY OUTPUT
Adjust the mist control so that the
mist rises up and gets absorbed
by the room air. Do not turn on
too high an output as the mist
cannot be absorbed by the air
and accumulates on the surface
around the humidifier.
If the humidifier is placed near a
fan or air conditioning outlet the
mist may be forced down by the
foreign air stream. Change the
location of the humidifier or
reduce the output of the other
room conditioning appliances.
Correct
Wrong
9
