English
GB15
8. Notes / warnings
Appendix A1
Trailer battery LED red:
• Symbol not lit up: Battery voltage is in
order.
• Slow flashing: Batteries should be char-
ged .
• 1x per second, continuous flashing and
3x acoustic warning: Batteries almost
empty. Charging is essential!
• LED permanently on and 10x acoustic
warning: Batteries deeply discharged.
The battery should be charged as soon as
possible, so that it does not get damaged.
Temperature indicator LED red:
• Symbol not lit up: Temperature of the
base station is in order
5x audible warning and LED flashes red:
• Temperature of the base station too high.
All driving functions are switched off. Let
the base station cool down! The system
can again be switched on once the base
station has cooled down.
Radio range indicator LED red:
• Symbol not lit up: Radio range is in order.
• 1x per second flashing: Radio range
exceeded. All driving functions are swit-
ched off. Reactivate the system by swit-
ching the remote control Off and On.
Fault in the MotorDrive:
• Motor drive LEDs flash and an
acoustic warning is provided
(10x). Communication with the
motor drive PC-board is not
possible. Check the connection.
• The corresponding icon flashes when swivelling
in and out. The system detects the respective end
position and indicates this by permanently illumi-
nating the corresponding icons.
• If the process of swivelling in/out is interrupted or
the end position if not detected, an audible war-
ning sounds (3x) and the corresponding icon flas-
hes (you should then check the drive units).
A1 Synchronisation
Synchronisation must be performed in the event of a
functional fault or following the exchange of electro-
nic parts. Proceed as follows:
Switch OFF the remote control
(= press once) as required
Switch off the base station as well.
Switch ON the remote control (= press
2x)
WKeep the forwards AND backwards
button pressed during the self-test. A
constant sound signal is produced and
the trailer symbol of the remote con-
trol flashes.
Switch on the base station.
The sound signal goes off and the trai-
ler symbol lights up permanently once
synchronisation has been completed.
Release the forwards and backwards
buttons. A short sound signal is pro-
duced.
The base station and the remote control are now syn-
chronised with each other.
The synchronisation is completed.
The remote control will switch OFF after approx. 60
seconds when no input is provided!
